|
|
 |
AC Servo Driver > CSD Series |
SPD | CSD-20-A
- Adopted the most advanced IGBT power module crystal.
- Series offers a variety of feedback component selection and the motor drive has the some synchronous and positioning control.
- Utilizes advanced MCU and DSP core for high-performance and efficiency.
- Control functions has position, speed and torque control mode.
- Built-in RS-232C and RS-485 communication interface to network with control drives.
- Required power supply 3-Phase 230V AC line voltage and 24V DC power supply voltage source.
|
|
|
Performance data |
CSD-20-A |
Input Voltage |
3 × 230 VAC ±10% |
Input Frequency |
47 ~ 63 Hz |
Input Current |
5.7 A |
Nominal Output Power |
2 KVA |
Efficiency |
94% (approximate) |
Power factor |
0.7 (approximate) |
Nominal Output Current |
6.1 A |
Peak Output Current |
12.2A / 25s |
Output Voltage |
3 × 190 VAC |
Output Frequency |
0 ~ 800 Hz |
Temperature |
5°C ~ 40°C |
Humidity |
5% ~ 85% |
Oscillation |
20 ~ 50 Hz 5.9 m/s2 below |
Settlement |
Indoor , Avoid direct sunlight , No corrosive gas / flammable gas /
oil / dust |
DC Supply Voltage Input Power |
24 Vdc ± 15% Maximum Ripple 5% |
Control method |
PWM |
Control mode |
Torque、Speed 、Position |
Protective function |
Over-Current、Over-Voltage、Under-Voltage、Short circuit、Heat Sink、Motor Over temperature、Ground Fault、Encoder Signal
|
Cooling |
Forced Cconvection |
Switching frequency |
16 KHz |
External brake resistor |
110 Ohm (minimum) |
Resistor continuous power |
300W |
Frequency bandwidth |
50 KHz |
Acceleration, Deceleration ramp |
1ms (minimum) |
Weight |
3.4 Kg |
Recommended cable cross-section [mm2/AWG]
|
J03 Motor PTC |
2 × 0.5 / AWG20 |
J04 Brake Resistor PTC |
2 × 0.5 / AWG20 |
J05 Braking Resistor (RBP, RBN) |
2 × 0.75 / AWG18 |
J06 DC BUS (DCP, DCN) |
2 × 1.25 / AWG16 |
J07 Motor (U, V, W) |
4 × 1.25 / AWG16 |
J08 Power Input (L1.1, L2.1, L3.1) |
3 × 1.25 / AWG16 |
PE connection [mm2/AWG] |
10 / AWG6 |
|
|
|
|
 |
|
