Please select language ：
 
 
        > SPD | CI-10-A
 
 
AC Servo Driver > CI Series

SPD | CI-10-A

  • Adopted the most advanced IGBT power module crystal.
  • Series offers a variety of feedback component selection and the motor drive has the some synchronous and positioning control.
  • Utilizes advanced MCU and DSP core for high-performance and efficiency.
  • Control functions has position, speed and torque control mode.
  • Built-in RS-232C and RS-485 communication interface to network with control drives.
  • Required power supply 290V~360V DC line voltage and 24V DC  power supply voltage source.



Performance data
CI-10-A
Input Voltage
290 ~360 Vdc
Input Current
3.3 A
Nominal Output Power
1 KVA
Efficiency
98% (approximate)
Nominal Output Current
3.3 A
Peak Output Current
6.6A / 10s
Output Voltage
3 × 190 VAC
Output Frequency
0 ~ 800 Hz
Temperature
5℃ ~  40℃
Humidity
5% ~ 85%
Oscillation
20 ~ 50 Hz   5.9 m/s2 below
Settlement
Indoor , Avoid direct sunlight , No corrosive gas / flammable gas /
oil / dust
DC Supply Voltage Input Power
24 Vdc ± 15% Maximum Ripple  5%   
Control method
PWM
Control mode
Torque、Speed 、Position 
Protective function
Over-Current、Over-Voltage、Under-Voltage、Short circuit、Heat Sink、Motor Over temperature、Ground Fault、Encoder Signal
Cooling
Forced convection
Switching frequency
16 KHz
Frequency bandwidth
100 KHz
Acceleration, Deceleration ramp
1ms (minimun) 
Weight
2.5 Kg
Recommended cable cross-section [mm2/AWG]
J03 Motor PTC
2 × 0.5 / AWG20
J09 Power Output Enable Handshake
3 × 0.75 / AWG18
J10 Power Output Enable 
3 × 0.75 / AWG18
J11 Power Output Enable POE / POE2 
4 × 0.75 / AWG18
J12 Power Output Enable Handshake
4 × 0.75 / AWG18
J08 Motor (U,V,W)
4 × 1.25 / AWG16
J09 DC BUS (DCP, DCN)
2 × 1.25 / AWG16
PE connection [mm2/AWG]
2 × 1.25 / AWG16